Every furnace call starts with a combustion and carbon monoxide safety check, not just a symptom fix.
Heat exchanger cracks, ignitor failures, and gas valve issues all fall within our scope.
Furnace failures carry a safety dimension — carbon monoxide and gas leaks — that most other hvac repairs don't, so the diagnostic has to start there, which is exactly why furnace repair calls in Andrews, IN get treated with urgency, not a next-available-Tuesday slot.

Waiting rarely saves money and often turns a same-day repair into a longer, more involved job.
AAA Pro HVAC built its furnace repair process around one idea: diagnose first, quote honestly, fix it right.
Every truck across Andrews, IN carries the tools and common parts specific to furnace repair, so most calls finish in a single visit.

Every furnace visit includes a combustion analysis and carbon monoxide test before any repair recommendation.
We carry manufacturer service manuals for major furnace brands.
No push toward replacement when a repair genuinely solves the problem.
We understand a dead furnace in winter is a pipe-freezing risk, not just a comfort issue.
From the first symptom to the final fix, these are the specific furnace repair services our Andrews-area crews are equipped for.
Hot surface ignitors crack over time and simply stop glowing — we test resistance rather than replacing on assumption. This is one of the most requested furnace repair calls we get across Andrews, IN.
Faulty gas valves are treated as a safety-critical repair, prioritized accordingly. This is one of the most requested furnace repair calls we get across Andrews, IN.
A cracked heat exchanger is a carbon monoxide risk and gets flagged immediately with the furnace shut down if needed. Techs handling heat exchanger inspection & repair carry the specific parts and tools this job calls for, not a generic kit.
We test motor amp draw against rated spec before replacement. This is one of the most requested furnace repair calls we get across Andrews, IN.
We inspect the full flue run, not just the connection at the furnace. Techs handling flue & venting repair carry the specific parts and tools this job calls for, not a generic kit.
We test low-voltage circuits before condemning the board. Techs handling thermostat & control board diagnostics carry the specific parts and tools this job calls for, not a generic kit.

Tell us the symptom — no ignition, cold air, gas smell, or error code — and we route accordingly.
Techs arrive with combustion analyzers and common ignitor/gas valve stock loaded.
Safety check first — combustion and carbon monoxide — then full mechanical diagnostics.
Heat exchanger findings are documented clearly regardless of outcome.

Tech tested the ignitor's resistance right in front of me and swapped it in under thirty minutes.
Old furnace was blowing cold air even though the blower ran fine.
They found a hairline crack in the heat exchanger I never would've noticed.
Thermocouple was the culprit, replaced and tested before the tech left.

Usually a failing ignitor or a fouled flame sensor — both are testable with the right equipment rather than replaced blind.
We'll walk you through options including repair versus replacement honestly.
This symptom shouldn't be ignored since it sometimes points to a safety-related fault.
Yes — our technicians are trained and certified on both fuel types.
Immediately — leave the area and call, don't attempt to diagnose it yourself.
Call dispatch for a live arrival estimate based on current demand.

Our furnace repair crews are positioned throughout Andrews, IN to keep response times realistic, not just promised.
☎ Call +1-866-805-8548 for Andrews Service